Joined: 17 Jan 2008 Posts: 76 Location: Port Talbot
Posted: Wed Apr 09, 2008 16:58 Post subject: Pump bleeding
Hi I have just replaced the cylinder head gasket but she won't start I think I need to bleed the injection system is it the bolt in the centre of the 4 feeds to the injectors? on the pump sorry if its been asked elsewhere I can't find. Thanks
Joined: 17 Jan 2008 Posts: 76 Location: Port Talbot
Posted: Thu Apr 10, 2008 15:59 Post subject:
Have just ordered a filter the one that is there is a bit poor, it was running okay before I took the cylinder head off (overheating fault).
I have bleed it many times Its starts with smoke everywhere and stops after 10-20 seconds but indeed will check out the pipes may be one of them has a crack in it. many thanks
Joined: 17 Jan 2008 Posts: 76 Location: Port Talbot
Posted: Fri Apr 11, 2008 17:26 Post subject:
Done a temp by pass of the primer fuel filter and then using a low pressure air into the fuel tank losen the beed screw turn ingnition on then pumped in the air the fuel ran out of the bleed screw. retighten bleed screw then started and she run but now big problem the exhast manifold is blowing even though i put a new gasket too scared to tight the ex man bolts too much incase the break off? If anyone had this problem be very helpful to know what to do i have tried other forums here but as yet not what this happend many thanks
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum