Isuzu Trooper Owners Club UK™

[paulwinship]

Can someone give me a quick low down on how to get to the injectors to get the serial numbers on my 3.0 TD.

IM say they were changed on 2006 and the software was checked April 09 but would like to reassure myself that the injectors are not part of a bad batch.

Presume its intercooler off etc???

[Google]

[waterbabies4x4]

i was told today as mine went in for a check today and the numbers are on the top of the injector but thats all i know at moment as trying to get the fault numbers to check my own when it comes back.......if you fine out the number post them on please thanks

[montifub]

Found this on another page of the forum and might help you,

Upto serial number 554263 your injectors will be changed
After serial number 554264 your injectors are ok and wont get replaced under the recall/campaign.

If any 1 of your injectors is before 554263 all 4 injectors will be renewed under the recall/campaign..
_________________

[paulwinship]

How do you actually get to them to read the numbers?

[Gribble]

REMOVAL
Prior to removal, be sure to confirm and record the
group code of the injector installed using Tech2.      ---------------- You can ignore that !
1. Disconnect battery ground cable.
2. Remove air cleaner cover and air duct.
3. Remove intercooler.
Refer to “Intercooler” in this manual.
4. Remove PCV hose and pipe.
5. Remove cylinder head noise insulator cover. ------------ Unbolt the throttle body to get this off its quicker'
6. Remove high pressure oil pipe.
CAUTION:
1) Sleeve nut should be loosened with cloth tied
around to prevent oil from spurting due to the
remaining pressure.
2) High oil pressure pipe should be disconnected
with cloth tied around the intake manifold glow
plug to prevent oil from flowing out of the oil
rail.
9. Remove PCV hose to cylinder head cover.
10. Remove cylinder head cover.
NOTE: Do not drop O-ring -------------------------------------- tiny ones in the pipe fitting ends.
12. Record the grade code of injector for each cylinder
that is indicated on the upper portion of injector.
There are nine kinds of grade code available, one
alphabet letter and one numeral letter.--------------------------------- you can read the s/n now
_________________
2 New Troopers !

[paulwinship]

Excellent, thanks Gribble.

How long will it take approx?

[Gribble]

Job to say as I dont know how good you are on the tools    takes me about 20 mins from start to finish off so an hour with tea break maybe ?
_________________
2 New Troopers !

[sbhep]

is it a sticker in the middle of the top of the injector

or are the numbers stamped in

I know mine had injectors replaced in 2005 but cannot find the numbers

thanks

[mechtrev]

we never did look at serial numbers of your spare ones Simon, hopefully I will get the sleeves replaced next weekend I will have a look at mine whilst I have them out even though they were checked in December and post my findings. If need be I will have to pop over and check yours simon or you will have to bring it to me.

[sbhep]

Hi Trev thats what I am on about they do seem to have any numbers on them

as I have found a dealer that will replace them under IZ 17 if they are the older ones

anyway good look with the injector sleaves

hope the old ones come out alright

[sbhep]

Thanks to the member for the pm

now found the numbers

if anyone else is having trouble like me

they are tiny little numbers about 1.5 to 2mm high

and are sort of etched into the the brown area in the middle of the injector

if you look down on them from above

i have booked in at the opticians to have eyes checked

just incase its me

cheers