View previous topic :: View next topic |
Author |
Message |
discodave *
Joined: 17 Aug 2013 Posts: 17 Location: Ireland/Leinster
|
Posted: Tue Aug 27, 2013 22:13 Post subject: |
|
|
That's what I thought ,
Timed it up to tdc and half moon to 6 , will the tech 2 tell me any more than my own launch do ya know ?
Getting a loan of one tomorrow either way |
|
Back to top |
|
|
Google Sponsor
|
Posted: Tue Aug 27, 2013 22:13 Post subject: Google Ads keep this community free to join! |
|
|
|
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Tue Aug 27, 2013 22:30 Post subject: |
|
|
might do, so look for injectors changing from disabled to enabled if they don't then you have no oil or cam or crank signal so check for an engine speed when cranking, you can't see the cam signal unfortunately but it very rarely goes wrong. then check the oil pressure is going up to at least 4mpa, also check what it says the batt voltage is if it's 5-7 volts but the engine is cranking over ok then the ecu is knackered, also check the rpcv increases up to nearly 100% after about 12 secs of cranking. |
|
Back to top |
|
|
discodave *
Joined: 17 Aug 2013 Posts: 17 Location: Ireland/Leinster
|
Posted: Tue Aug 27, 2013 22:42 Post subject: |
|
|
Thanks for the help ill post up if I get any further info tomorrow it might be later in the week though depending on when I can get my hands in the gizmo.
Thanks again. |
|
Back to top |
|
|
ptrustfull Newbie
Joined: 06 Dec 2013 Posts: 1 Location: Paramaribo
|
Posted: Fri Dec 06, 2013 10:57 Post subject: |
|
|
any progress? I'm having the same problem and can learn from your experience |
|
Back to top |
|
|
discodave *
Joined: 17 Aug 2013 Posts: 17 Location: Ireland/Leinster
|
Posted: Mon Dec 09, 2013 2:05 Post subject: |
|
|
Hi.
After going through all the tricks put up here I tried to get a loan of a tech2 ,
Couldn't so went out and bought one.
After it arrived I spent 2 weeks getting the correct software then I diagnosed the pig in 10 seconds as a faulty rops ,
Got the bit a few weeks ago but been busy with other jobs so hoping to have it done this side of Christmas.
Best of luck |
|
Back to top |
|
|
Mike Rosie **
Joined: 16 Nov 2005 Posts: 101
|
Posted: Wed Jan 29, 2014 7:20 Post subject: |
|
|
Hi
Where did you get the tech 2
Is it a Chinese one and if so is it any good ?
I have been thinking of getting one for a while now but so many mixed reports about the Chinese ones
Mike |
|
Back to top |
|
|
|