View previous topic :: View next topic |
Author |
Message |
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Thu Aug 08, 2019 19:29 Post subject: |
|
|
Checked today and it has the normal 16 pin EOBC socket hanging down under the steering colunm.. 6x wires going to it.. Thanks |
|
Back to top |
|
|
Google Sponsor
|
Posted: Thu Aug 08, 2019 19:29 Post subject: Google Ads keep this community free to join! |
|
|
|
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Thu Aug 08, 2019 19:32 Post subject: |
|
|
should be 6 and 4 then |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Thu Aug 08, 2019 19:46 Post subject: |
|
|
Excellent.. will check it out first thing.. Thanks |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Fri Aug 09, 2019 12:50 Post subject: Codes |
|
|
Hi,
Bridged pins 4&6 engine light flashed.. 2...4 repeatedly..
Where can I locate a list of the codes...?
Thanks,
Dave. |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Fri Aug 09, 2019 13:02 Post subject: |
|
|
That’s code 24 then |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Fri Aug 09, 2019 15:27 Post subject: |
|
|
What does code 24 relate to...? Thanks |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Fri Aug 09, 2019 15:44 Post subject: |
|
|
There’s a sticky in the transmission section with all fault codes in it |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Fri Aug 09, 2019 17:35 Post subject: Codes |
|
|
VSS Vehicle speed sensor... Getting closer, would this fault cut the engine at 3300 rpm.? where is the VSS located as it may just be that it has been over looked and just needs plugging in fingers crossed... |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Fri Aug 09, 2019 17:40 Post subject: |
|
|
although did you read the bit about the converter? theres one on the back of the gearbox where the rear prop comes out and theres another built in to the speedo clock i think |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Fri Aug 09, 2019 18:03 Post subject: |
|
|
Hi Eithan,
I did read that part too, just thought it related to a faulty speedo not an engine cutting out..?? |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Sat Aug 10, 2019 9:58 Post subject: |
|
|
Checked the plug in the back of the gearbox, hadn't been disturbed, speedo again hasn't been touched.
VSS is there to signal the speedo, can't see how it could contribute to our engine cutting out fault..??
24 was the only fault code shown when bridging pins 4&6.
As we do not have any codes to work with what could cause a 3.1 Trouper to stop dead at 3300 rpm??
Is there a fuel cut off device?
It has an electric pump I believe, how is this controlled ?
Truck drives fine just keep the rev's below 3300 and all is well..
Answers on a post card to this post please.
Thanks.. |
|
Back to top |
|
|
rekab6969 *
Joined: 16 May 2019 Posts: 22 Location: Suffolk UK
|
Posted: Sun Aug 18, 2019 12:06 Post subject: Back from holiday.. |
|
|
Anyone...?? |
|
Back to top |
|
|
|