View previous topic :: View next topic |
Author |
Message |
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Fri May 15, 2020 16:23 Post subject: Rodeo 2006 electronic fuel pump |
|
|
I have a 2006 Rodeo 2.5, with the electronic fuel pump. For a couple of years I haven't been able to drive, so she was turned over regularly but became smoky. I did a fuel service, left her on tick over. The smoke got worse, looked like diesel. It stopped and refused to start again! Cutting a long story short I replaced everything from the tank to the engine. Dropped the tank and cleaned it out. Replaced the fuel filter and hand pump underneath. Bled it all and got good pressure to the electronic pump, but little coming out of the pipes to the injectors. Oh injector pump? Got another, swapped the electronics over to the new pump, and little came out of that either. I've tried everything other than the relay or perhaps is there an electric pump in the tank I didn't realise? I know this is doubtful as there is the hand pump on top of the filter. The engine has done 100k. I've owned it since 19k serviced it every 5k. The engine is quiet running never uses oil, and has always started first time. It is immaculate and I want to run it forever other than this little hick up! I am disabled so jobs take me a little longer. I had to buy a cheap run around whilst I attempt to sort it. Can anyone help with suggestions I might of missed please. Yes I have a manual but find it inconsistent with this model. The 2.5 in question has timing gears, although the markings differ from the manual, ha! Many thanks in anticipation. Dave. |
|
Back to top |
|
|
Google Sponsor
|
Posted: Fri May 15, 2020 16:23 Post subject: Google Ads keep this community free to join! |
|
|
|
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Fri May 15, 2020 18:02 Post subject: |
|
|
pumps are not coded you can just swap them over with no issues, the pump is also a common failure point as well, have you tried bridging pins 6 and 4 in the drag plug and seeing if theres any fault codes via the flashing of the check engine light |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Fri May 15, 2020 18:30 Post subject: |
|
|
Hi, thank you for that. I will try bridging tomorrow. Interestingly no faults have come up at present anyway! |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 10:57 Post subject: |
|
|
Hi again, nothing happening at the dash at all. No error codes or flashing of anything. I wired the last two together in the plug which I think is 4 and 6 (to the right as you look at it. |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Sun May 17, 2020 11:48 Post subject: |
|
|
Doesn’t sound like the right pins |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 13:52 Post subject: |
|
|
OK as you look at the plug there are a group of four in a square then blanks then the last two. I looped the last two. |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 14:22 Post subject: |
|
|
Brilliant thank you. I'll try now. |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 14:40 Post subject: |
|
|
The engine line flashes but no codes come up? |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 14:40 Post subject: |
|
|
Sorry should say light flashes. |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Sun May 17, 2020 14:45 Post subject: |
|
|
count the flashes it will flash say 3 times then will pause for a second then flash say 6 times this is code 36 then it will pause then will carry on wither any other codes or will repeat the 36 again |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 15:01 Post subject: |
|
|
Can't get it to flash at all now but did do three and a six earlier. |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 15:59 Post subject: |
|
|
cracked it. 35/44/45/53/12/54. mmmmmmmmm! |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Sun May 17, 2020 17:10 Post subject: |
|
|
35 is system voltage
45 is cam speed malfunction
53 is injection pump malfunction
54 is injection timing control circuit malfunction
44 is can device offline
12 is normally start of codes |
|
Back to top |
|
|
DaveCrofts *
Joined: 15 May 2020 Posts: 11 Location: Nottinghamshire
|
Posted: Sun May 17, 2020 19:12 Post subject: |
|
|
Thank you. I take it is is the pump then or is there more issues around there. Where should I start (again) please. Shame you are not nearer. Thanks again. Dave. |
|
Back to top |
|
|
|