|
Isuzu Trooper Owners Club UK™ Isuzu Trooper, Rodeo, Bighorn, Mu & VehiCROSS Owners Club
|
View previous topic :: View next topic |
Author |
Message |
Nor **
Joined: 01 Nov 2015 Posts: 54 Location: far away - Ski, Norway
|
Posted: Sun Jul 02, 2017 15:03 Post subject: TOD ECU 4 jx1 2000 |
|
|
Hi, I have some problem With 4x4 system and have tried to read all post on the forum. The TOD Box under right seat is numbered
8972047910 while T2 says it is 8971826820 alpha code Eu Electronic system TOD. Im confused cause 8971826820 is supposed to fit 97-
99 models. Mine is a 2000 (Y).
No error codes for the Box though.
At the moment only error code 32, but sometimes 21 and 33.
Need help here and any comments higly appreciated!
Bregards
NOR _________________ Isuzu Trooper 3.0TD 2002
Fiat Ducato 2,3 jtd 2006sold
Ford Focus turnier 1,6 autosold
Ford Mondeo turnier 1,6 tdci econetic |
|
Back to top |
|
|
Google Sponsor
|
Posted: Sun Jul 02, 2017 15:03 Post subject: Google Ads keep this community free to join! |
|
|
|
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Sun Jul 02, 2017 16:55 Post subject: |
|
|
whats it doing and are they tod codes or engine codes? |
|
Back to top |
|
|
Nor **
Joined: 01 Nov 2015 Posts: 54 Location: far away - Ski, Norway
|
Posted: Sun Jul 02, 2017 17:21 Post subject: |
|
|
Hi Eithan, car runs like its in limp home mode (code 33) With little Power ,and theres no clicking in the vsvs.
Measured ca 9,5 volts at blue and grey connectors. VSVs bench tested and they Works.
Both 2 + 4 wd hoses on actuator fron With vacuum.
Cant hear any click from the rear. Speed sensor changed.
Code 32 say axle disconnect ouput Circuit low or ground. Today,only got code 32 on t2.
Also checked vacuum hoses and seems fine, but Close to the engine ecu its an air filter for the vacuum hose but also to other hoses
with no end. Is that correct? no suction here.
But what about the TOD box/transfer Control unit? I was going to measure the Connections as per Trooper manual for error code 32 + 33
but the pins to measure is not as outlined on section 4B2-23 in manual
Axle switch front looks a bit tired but bench test ok. Maybe internal short?
Regards
Nor _________________ Isuzu Trooper 3.0TD 2002
Fiat Ducato 2,3 jtd 2006sold
Ford Focus turnier 1,6 autosold
Ford Mondeo turnier 1,6 tdci econetic |
|
Back to top |
|
|
Nor **
Joined: 01 Nov 2015 Posts: 54 Location: far away - Ski, Norway
|
Posted: Sun Jul 02, 2017 18:51 Post subject: |
|
|
Forgot to say codes on TOD(chassis)
Red check light flashes fast.
Car is very little used the last Three years. Mostly standing still.
Red check light flashed a couple of years ago but went out when turning ign. off and restarting.
Green TOD lights may or may not flash in any pos.
Low gir ok. _________________ Isuzu Trooper 3.0TD 2002
Fiat Ducato 2,3 jtd 2006sold
Ford Focus turnier 1,6 autosold
Ford Mondeo turnier 1,6 tdci econetic |
|
Back to top |
|
|
Nor **
Joined: 01 Nov 2015 Posts: 54 Location: far away - Ski, Norway
|
Posted: Mon Jul 03, 2017 11:21 Post subject: |
|
|
So, local IM garage confirmed transfer Control module 8972047910 is the correct one.
Was playing With T2 and looked at the ABS DTCs and it showed up 24 not present 4 x 4 switch error.
Is this the same axle switch as the one mounted on the front actuator? _________________ Isuzu Trooper 3.0TD 2002
Fiat Ducato 2,3 jtd 2006sold
Ford Focus turnier 1,6 autosold
Ford Mondeo turnier 1,6 tdci econetic |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Mon Jul 03, 2017 19:20 Post subject: |
|
|
no as the 4wd system isn't part of the obd system, the tod part is just the transfer box so there must be a switch on that that tells the ecu it's in 4wd.
the pipes by the ecu are breather pipes there shouldn't be any suction on them and it won't matter if that air filter bit is on it or not |
|
Back to top |
|
|
Nor **
Joined: 01 Nov 2015 Posts: 54 Location: far away - Ski, Norway
|
Posted: Mon Jul 03, 2017 20:13 Post subject: |
|
|
Thank you for Your reply,
So, does this indicate that there might be an internal error in the TOD ecu if the switch is an integral part of it?
Or does this occure because of other error/s, such as the ABS error code 24 or the 32 on the powertrain? Next
would maybe be to check the ABS EHCU Connector pin-out check note 9.
I still dont understand why the T2 says TOD ecu is 8971826820 and pls confirm by pressing enter (or F1), when
it In Fact is TOD ecu 8972047910 Stock from the factory. Can this cause the error codes ? _________________ Isuzu Trooper 3.0TD 2002
Fiat Ducato 2,3 jtd 2006sold
Ford Focus turnier 1,6 autosold
Ford Mondeo turnier 1,6 tdci econetic |
|
Back to top |
|
|
eithan h Moderator
Joined: 11 Dec 2005 Posts: 8195 Location: oxfordish
|
Posted: Tue Jul 04, 2017 19:30 Post subject: |
|
|
switch would be a bolt on part on the transfer box somewhere not the ecu |
|
Back to top |
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|